Shower doors backsplash glass partition glass table top sliding doors glass panel tempery glass laminated glass pieces of glass lamination glass tinte Conditions of installation and preparation
We recommend to take into account when ordering la...
Shower doors backsplash glass partition glass table top sliding doors glass panel tempery glass laminated glass pieces of glass lamination glass tinte Conditions of installation and preparation
We recommend to take into account when ordering large items:
1. Possibility of parking the car at the place of unloading.
2. Dimensions (width, length, height) of the hall. *
3. Dimensions (width, length, height) flight of stairs and floor areas. *
4. If you have the opportunity to lift freight elevator products on it. **
5. Overall dimensions (width, length, height) tambour front doorway and the door opening. ***
6. The possibility of skidding product and its positioning relative to the plane of installation:
- The height and width of doorways ***
- Dimensions (width, length, height) of the corridor *
- Dimensions (width, length, height) of the room in which you plan to make installation work *
- Opening side doors for opportunities rackets and turn the product.
* The length of the diagonal of the product must not exceed the height of the ceiling and should be less than the ceiling height of 15 inches
** The maximum size is lifted on the freight elevator products 79 inch h 63 inch at Spreading wings
*** The length of the short side of the product should not exceed the length of the diagonal of the aperture and must be at least 8 inches
- When you install a height of 6 ft from the bottom of the product installation costs doubled;
- Minimal installation costs - $ 50;
- The dismantling considered for installation costs dismantled products;
Recommendations for the preparation of surfaces for mounting the mirror and glass products:
Surface, which will be the installation of mirror and glass products must comply with the requirements of:
For surfaces, which will be the installation of mirror and glass products, it is recommended to use oil paints (not enamel).
Before painting the surface of the primer coating at least 2 times with intermediate drying.
Prohibits the use of paints and primers with acrylic additives.
Painted (primed) surfaces are dried naturally, without the use of heaters, accelerate drying. The duration of drying layers is determined by the instructions for use of these materials.
On the deposited layer of plaster is not permitted metal lighthouses.
Quality control of the prepared surface:
Geometric deviations must comply with the standard
Control tack: stick to the prepared surface strip double-sided tape and try to tear it.
On a properly prepared surface is taped or most of it.
If the adhesive tape does not stick to the prepared surface or off with a fragment of paint - for the work surface
Read more
Show less
